|
[<<< Back, to the category overview]
Add to the basket for $29 US dollars
So you can optimize a DXF if you want for example cut or mill the file later on. The optimization minimizes the time needed to cut the file. You can setup a starting point in DXF coordinates before the sorting process. The program will then start with the DXF element which is the nearest to the starting point.
You can use this program before you convert the DXF file into G-Code with our program DXF to G-Code.
If you want to convert small lines into arcs you can use our program DXF small lines to arcs.
|
|||